Machine Shields from Danray
Danray has a large selection of machine safety products and
accessories including machine safety shields, lathe chuck
shields, portable (handheld) chip/coolant shields, machine
lamps, safety signs and more. These products can be
used with metalworking and woodworking machinery such as drill
presses, milling machines, grinders, lathes, and saws.
Lathe Chuck Shields
Danray
heavy-duty lathe chuck shields are designed to apply to lathes
or other similar machine applications. The shield provides a
barrier between the chuck and work piece and the operator. The
shield also deflects chips, coolant, and other particles. The
shield hinges left and rests at a 45° angle above the headstock,
making it easy to change the chuck or work piece. The operator
doesn’t need to reach over the chuck to move the shield in and
out of position (which is a possible safety hazard), and the
shield will not interfere with lathes that have a rear
guard/backsplash.
Portable Safety Shields
Polycarbonate
portable safety shields can be used on mills, drills, lathes,
and any other machines that need a handheld or attached shield
to protect the operator. They are available in two sizes. The
large shield has various configurations. The shield can be
stored on the machine, a wall, or a post by hanging the shield
on the hook provided.
Snake Arm Shields
Snake-arm
shields are designed to apply to a wide variety of machinery and
equipment that need point-of-operation safeguarding. The shields
have the ability to be moved easily in and out of the
safeguarded position for tool changes or they can be readjusted
to fit various machine applications. Our snake-arm shields serve
two functions: (1) they provide a safeguard between people and a
point-of-operation hazard, and (2) they protect people from
flying chips, sparks, coolant, lubricant, and other particles
generated by a machine or its tooling.
Snake Arm Lamps
Snake-arm
lamps are available with three different mounting styles:
direct, C-clamp, and magnetic. The direct-mount base can be
fastened to most any flat surface at least 2" x 1" with two
included 1/4" fasteners. The C-clamp base can be mounted to a
table or ledge up to 1 7/8" thick. The magnetic base consists of
a 3 1/4"-diameter magnet with 100 pounds of holding force.
Several safety standards for machine tools require that lighting
must be installed to ensure that personnel can safely perform
their tasks.
Safety Signs
Safety
signs are intended to identify and warn against specific
hazards. They should be affixed to a prominent location on the
machine or equipment so that they are easily seen and understood
by individuals in the hazard area. Our one-of-a-kind, U.S.
Copyright Office–registered signs have been designed to comply
with OSHA 29 CFR 1910.145 and the ANSI Z535 series of standards
for the design, application, and use of signs, colors, and
symbols for accident prevention. These signs can be applied to
manual and automatic metal- and woodworking machines and other
equipment.
Safety Scales
Danray
Products' safety scales can be used to check for compliance of
bench grinders and barrier guards with applicable machine-safety
standards. Our guard safety scale can be used to check the
openings of barrier guards for compliance with ANSI B11-series
safety standards for machine tools; the ANSI/RIA R15.06 safety
standard for industrial robots and robot systems; and Canadian
safety standards CSA Z142 for power presses, CSA Z434 for
robots, and CSA Z432 for safeguarding of machinery. The folding
scale has English units on one side and metric units on the
other. It can be used during the design, installation, and
inspection of barrier guards to make sure they comply with ANSI
and CSA machine safety standards.
Contact Guardomation
Please contact
Guardomation for technical, applications engineering and
sales assistance for your machine guarding and safety requirements.
|